Lexus NX: Trip Switch
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 INSTRUMENT SIDE PANEL LH *2 NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY *3 TRIP SWITCH - -
Removal
REMOVAL PROCEDURE 1. REMOVE INSTRUMENT SIDE PANEL LH Click here 2. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Click here 3. REMOVE TRIP SWITCH (a) Using a screwdriver, detach the
Inspection
INSPECTION PROCEDURE 1. INSPECT TRIP SWITCH *1 ODO TRIP Switch *a Component without harness connected (Trip Switch) (a) Check the resistance. Measure the resistance according to the val
SEE MORE:
Sound Quality is Bad Only when Disc is Played (Volume is Too Low)
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
Drive Motor "B" Control Module (P0A1C-693,P0A1C-812)
DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate that a large current flowed in the inverter for the rear motor. The cause of this malfunction may be one of the following: Internal inverter malfunction
Internal circuit malfunction in the inverter for the rear motor
Malfunction in ECU tha
© 2016-2026 Copyright www.lexunx.com
