Lexus NX: Removal
REMOVAL
PROCEDURE
1. PRECAUTION
(a) w/ Parking Assist Monitor System:
Click here .gif)
(b) w/ Panoramic View Monitor System:
Click here
2. REMOVE BACK DOOR TRIM BASE (w/ Power Back Door)
Click here
3. REMOVE PULL HANDLE (w/ Power Back Door)
Click here
4. REMOVE BACK DOOR FINISH COVER LH (w/o Power Back Door)
Click here
5. REMOVE BACK DOOR FINISH COVER RH (w/o Power Back Door)
Click here
6. REMOVE BACK DOOR LOCK COVER (w/ Power Back Door)
Click here
7. REMOVE BACK DOOR LOCK COVER (w/o Power Back Door)
Click here
8. REMOVE BACK DOOR CENTER GARNISH
Click here
9. REMOVE BACK DOOR SIDE GARNISH LH
Click here
10. REMOVE BACK DOOR SIDE GARNISH RH
Click here
11. REMOVE BACK DOOR TRIM BOARD ASSEMBLY
Click here
12. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Click here
13. REMOVE REAR TELEVISION CAMERA ASSEMBLY
| (a) Disconnect the connector. |
|
| (b) Remove the 2 screws and rear television camera assembly. |
|
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR TELEVISION CAMERA ASSEMBLY (a) Install the 2 screws and rear television camera assembly. (b) Connect the connector. 2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSE
Components
COMPONENTS ILLUSTRATION *1 FRONT DOOR INSIDE HANDLE BEZEL PLUG LH *2 FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH *3 FRONT DOOR TRIM COVER LH *4 OUTER MIRROR INSTALL HOLE COVER LH *5
SEE MORE:
Parts Location
PARTS LOCATION ILLUSTRATION *1 FORWARD RECOGNITION CAMERA *2 BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (SKID CONTROL ECU) *3 HEADLIGHT ASSEMBLY LH *4 HEADLIGHT ASSEMBLY RH *5 ENGINE ROOM RELAY BLOCK - H-LP LH/DIMMER(HI) RELAY (for Single Beam Headlight) *6 NO. 2 ENGIN
HV Main Relay (P3110-223)
DESCRIPTION The hybrid vehicle control ECU monitors the IGCT relay and detects the following malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P3110-223 HV Main Relay IGCT relay stuck on (+B short): IGCT relay is stuck on or a short to
