Lexus NX: Screen Flicker or Color Distortion
Lexus NX Service Manual / Audio & Visual & Telematics / Audio / Video / Audio And Visual System / Screen Flicker or Color Distortion
PROCEDURE
| 1. | CHECK DISPLAY SETTING |
(a) Reset display settings (contrast, brightness) and check that the screen appears normal.
OK:
The display returns to normal.
| OK | .gif) | END (DISPLAY SETTING WAS CAUSE OF MALFUNCTION) |
| NG | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
.gif)
READ NEXT:
Poor Sound Quality in All Modes (Low Volume)
PROCEDURE 1. CHECK AUDIO SETTINGS (a) Set treble, middle and bass to the initial values and check that the sound is normal. OK: The sound returns to normal. HINT: Sound quality adjustment me
"No GPS signal" mark is displayed
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
Voice Guidance does not Function
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU CHECK FORWARD RECOGNITION CAMERA NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
Do not apply larger loads than necessary since the connector may be
Telematics Transceiver Disconnected (B15DB)
DESCRIPTION If the radio receiver assembly cannot detect the DCM (telematics transceiver) for a certain period of time (90 seconds) after the power switch is turned on (IG) and the radio receiver assembly confirms that the information is missing by checking past DCM (telematics transceiver) recognit
© 2016-2026 Copyright www.lexunx.com
