Lexus NX: Slip Indicator Light does not Come ON
DESCRIPTION
The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication.
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve.
Click here .gif)
PROCEDURE
| 1. | CHECK CAN COMMUNICATION SYSTEM |
(a) Check if CAN communication system DTCs are output.
Click here
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
| B | .gif) | INSPECT CAN COMMUNICATION SYSTEM |
|
.gif)
| 2. | PERFORM ACTIVE TEST USING TECHSTREAM (SLIP INDICATOR LIGHT) |
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Select the Active Test on the Techstream.
Click here
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Slip Indicator Light | Slip indicator light | Indicator light ON/OFF | Observe combination meter assembly |
(d) Select the Data List on the Techstream.
Click here
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Slip Indicator Light | Slip indicator light | ON or OFF | ON: Indicator light on OFF: Indicator light off | - |
| Active Test Display |
|---|
| Slip Indicator Light |
| Data List Display |
|---|
| Slip Indicator Light |
(e) Check the operating condition of the slip indicator light when operating it using the Techstream.
| Result | Proceed to |
|---|---|
| Slip indicator light in the Data List does not change using the Active Test. | A |
| Slip indicator light in the Data List turns ON/OFF using the Active Test. | B |
| A | | REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY |
|
| 3. | INSPECT COMBINATION METER ASSEMBLY |
(a) Turn the power switch off.
(b) Perform the Active Test of the combination meter assembly (meter CPU) using the Techstream.
Click here
| Tester Display |
|---|
| Indicat. Lamp Slip |
(c) Check the combination meter assembly.
OK:
The slip indicator light turns on or off in accordance with the Techstream operation.
| OK | | REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY |
| NG | | INSPECT METER / GAUGE SYSTEM |
READ NEXT:
VSC OFF Switch Circuit
DESCRIPTION The skid control ECU assembly is connected to the combination meter assembly via CAN communication. Pressing the VSC OFF switch turns off TRAC operation, and pressing and holding this swit
Components
COMPONENTS ILLUSTRATION *A w/ AVS - - *1 FRONT SKID CONTROL SENSOR WIRE LH *2 FRONT SPEED SENSOR LH N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *A
SEE MORE:
Registration
REGISTRATION CAUTION / NOTICE / HINT NOTICE: The Vehicle Identification Number (VIN) must be input into a replacement ECM. HINT: The VIN is a 17-digit alphanumeric vehicle identification number. The Techstream is required to register the VIN. PROCEDURE 1. DESCRIPTION HINT: This registration section
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY LH Click here 2. REMOVE FRONT LOWER SEAT CUSHION SHIELD Click here 3. REMOVE FRONT SEAT CUSHION SHIELD LH Click here 4. REMOVE FRONT INNER S
