Lexus NX manuals

Lexus NX: Speaker Circuit (B1350)

Lexus NX Service Manual / Vehicle Exterior / Acoustic Vehicle Alerting System / Acoustic Vehicle Alerting System / Speaker Circuit (B1350)

DESCRIPTION

The vehicle approaching speaker assembly circuit consists of the vehicle approaching speaker controller and vehicle approaching speaker assembly.

This DTC is stored when a malfunction is detected in the vehicle approaching speaker assembly circuit or vehicle approaching speaker controller.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B1350

Speaker Circuit
  • The power switch is on (IG).
  • IG power source voltage is 10 V or more.
  • When ECU output sound signal is being monitored with warning sound not being output, a speaker circuit open, short or short to ground is detected.
  • When vehicle proximity warning sound output conditions are met, an internal malfunction is continuously detected in the vehicle approaching speaker controller.
  • 6 seconds or more
  • 3 seconds or more
  • Vehicle approaching speaker controller
  • Vehicle approaching speaker assembly
  • Harness or connector

WIRING DIAGRAM

PROCEDURE

1.

INSPECT VEHICLE APPROACHING SPEAKER ASSEMBLY

(a) Remove the vehicle approaching speaker assembly.

Click here

(b) Inspect the vehicle approaching speaker assembly.

Click here

NG

REPLACE VEHICLE APPROACHING SPEAKER ASSEMBLY

OK

2.

CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER ASSEMBLY - VEHICLE APPROACHING SPEAKER CONTROLLER)

(a) Disconnect the A80 vehicle approaching speaker controller connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

A79-2 - A80-7 (SP+)

Always

Below 1 Ω

A79-1 - A80-8 (SP-)

Always

Below 1 Ω

A79-2 or A80-7 (SP+) - Body ground

Always

10 kΩ or higher

A79-1 or A80-8 (SP-) - Body ground

Always

10 kΩ or higher
OK

REPLACE VEHICLE APPROACHING SPEAKER CONTROLLER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

READ NEXT:

 Lost Communication with Brake System Control Module (U0129,U0140,U0293)

DESCRIPTION These DTCs are stored when the CAN communication system is malfunctioning. DTC No. Detection Item DTC Detection Condition Trouble Area U0129 Lost Communication with Brake Sy

 There is No Sound Made

DESCRIPTION Based on signals received from each ECU, the vehicle approaching speaker controller outputs warning sounds through the vehicle approaching speaker assembly. WIRING DIAGRAM CAUTION / NOTIC

 Vehicle Approaching Speaker

ComponentsCOMPONENTS ILLUSTRATION *1 RADIATOR SUPPORT OPENING COVER *2 VEHICLE APPROACHING SPEAKER ASSEMBLY N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDU

SEE MORE:

 Park / Neutral Position Switch Circuit

DESCRIPTION The fold seat control ECU receives switch operation signals, back door open/close signal*1, rear door open/close signal*2 and driving condition signal (shift position, stop light switch assembly, parking brake switch assembly signals) from the main body ECU (multiplex network body ECU).

 Actuator Malfunction (C13A7)

DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note C13A7 Actuator Malfunction Both of following conditions are met: Electric parking brake is operating One of following is detected: Motor lock, gear lock, spinning, repeated slipping

© 2016-2026 Copyright www.lexunx.com