Lexus NX: Tire Pressure Warning Valve
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 TIRE PRESSURE WARNING VALVE AND TRANSMITTER *2 WASHER *3 VALVE CORE *4 GROMMET *5 NUT *6 VALVE CAP N*m (kgf*cm, ft.*lbf): Specified torq
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL Click here 2. REMOVE REAR WHEEL Click here 3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER (a) Remove the valve cap and valve core to release the air
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE:
Always use a new grommet and valve core when installing the tire pressure warning valve and transmitter.
Check that the washer and nut are not damaged
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: If the main body ECU (multiplex network body ECU) is replaced, refer to Registration. Click here HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY (a) Attach the guide and install the No. 1 amplifier antenna assembly with the bolt. Torque: 8.3 N·m {85 kgf·cm, 73 in·lbf} (b) Connect the 2 connectors. 2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY Click here 3. INSTALL BACK DOOR
© 2016-2026 Copyright www.lexunx.com
