Lexus NX: Tire Pressure Monitoring

Lexus NX Service Manual / Suspension / Tire Pressure Monitoring

READ NEXT:

 Tire Pressure Warning Initiator (for Front Side)

ComponentsCOMPONENTS ILLUSTRATION *1 FRONT TIRE PRESSURE MONITOR INITIATOR *2 CONNECTOR N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. PRECAUTION CAU

 Tire Pressure Warning Initiator (for Rear Side)

 Components

COMPONENTS ILLUSTRATION *1 QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH *2 REAR BUMPER SIDE SEAL LH *3 REAR TIRE PRESSURE MONITOR INITIATOR *4 REAR WHEEL HOUSE FRONT PLATE LH *5

SEE MORE:

 Vehicle Control History

VEHICLE CONTROL HISTORY NOTICE: When checking the Vehicle Control History, make sure to record the output codes. Then, clear the Vehicle Control History (RoB) and check it again. CHECK VEHICLE CONTROL HISTORY (FRONT RADAR SENSOR SYSTEM) (a) Connect the Techstream to the DLC3. (b) Turn the power swit

 Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL NO. 3 MOULDING TAPE (a) Clean the No. 3 moulding tape installation surface. (1) When reusing the side mudguard LH, remove the double-si

© 2016-2024 Copyright www.lexunx.com