Lexus NX: Tongue Plate Stopper
Components
COMPONENTS
ILLUSTRATION
| *1 | TONGUE PLATE STOPPER | - | - |
| ● | Non-reusable part | - | - |
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE TONGUE PLATE STOPPER
| (a) Slide the tongue plate above the installation position of the tongue plate stopper, and temporarily hold it with adhesive tape. |
|
(b) Remove any pieces of the original tongue plate stopper in the belt webbing with a pair of pliers.
NOTICE:
Be careful not to damage the belt webbing during repair.
2. INSTALL TONGUE PLATE STOPPER
| (a) Position a new tongue plate stopper in the hole of the belt webbing. HINT: Make sure that the installation direction of the tongue plate stopper is as shown in the illustration. |
|
| (b) Hold the tongue plate stopper in the hole of the belt webbing using an adjustable wrench, and turn the adjustment screw of the adjustable wrench by hand to compress the tongue plate stopper. NOTICE:
HINT: Tape the jaws of the adjustable wrench before use. |
|
| (c) When the adjustment screw of the adjustable wrench can no longer be turned by hand, tighten the adjustment screw using a pair of adjustable joint pliers until the tongue plate stopper thickness is 4.5 to 5.0 mm (0.177 to 0.197 in.). (Refer to the illustrations.) Standard Clearance
|
|
| (d) Make sure that the male pin of the tongue plate stopper has expanded evenly in the hole of the female part and is firmly held to the belt webbing. (Refer to the illustrations.) |
|
READ NEXT:
Precaution
PRECAUTION CAUTION:
This vehicle is equipped with a Supplemental Restraint System (SRS), which consists of a horn button assembly, instrument panel passenger airbag assembly, curtain shield airbag
SEE MORE:
Internal Control Module Software Incompatibility Not Programmed (U030051)
DESCRIPTION If the forward recognition camera cannot verify the vehicle information sent from the hybrid vehicle control ECU, the forward recognition camera stores DTC U030051. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from U030051 Internal Control Modul
Front Radar Sensor Optical Axis Misalignment Malfunction (C1A1100)
DESCRIPTION The millimeter wave radar sensor assembly performs self-diagnosis to check for misalignment of its beam axis. If misalignment is detected, the millimeter wave radar sensor assembly stores DTC C1A1100. DTC No. Detection Item DTC Detection Condition Trouble Area C1A1100 Fron
