Lexus NX: Seat Belt
Lexus NX Service Manual / Vehicle Interior / Seat Belt
- Front Seat Inner Belt Assembly
- Front Seat Outer Belt Assembly
- Rear Center Seat Outer Belt Assembly
- Rear Seat Inner Belt Assembly
- Rear Seat Outer Belt Assembly
- Seat Belt Tension Reducer System
- Seat Belt Warning Light (for Rear Side)
- Seat Belt Warning System
- Tongue Plate Stopper
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT SEAT INNER BELT ASSEMBLY LH *2 FRONT SEAT INNER BELT ASSEMBLY RH *3 FRONT SEAT BELT ANCHOR PLATE - - N*m (kgf*cm, ft.*lbf): Specified torque
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SEAT ASSEMBLY LH Click here 2. REMOVE FRONT SEAT ASSEMBLY RH HINT: Use the same procedure as for the driver seat. 3. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (a) D
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL FRONT AIRBAG SENSOR LH (a) Check that the power switch is off. (b) Check that the cable is disconnected from the negative (-) auxilia
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR (a) Install the No. 2 exhaust manifold heat insulator with the 2 bolts. Torque: 13.5 N·m {138 kgf·cm, 10 ft·lbf} 2. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (a) Install a new exhaust manifold to head gasket to the cyl
© 2016-2025 Copyright www.lexunx.com
