Lexus NX: Window Defogger System
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Problem Symptoms Table
- Data List / Active Test
- Rear Window Defogger System does not Operate
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 AIR CONDITIONING CONTROL ASSEMBLY - REAR WINDOW DEFOGGER SWITCH *2 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - ECU-IG NO.1 FUSE - ECU-IG NO.3 FUSE *3 DLC3
System Diagram
SYSTEM DIAGRAM Communication Table Transmitter Receiver Signal Communication Method Air Conditioning Control Assembly Air Conditioning Amplifier Assembly Rear window defogger switch
System Description
SYSTEM DESCRIPTION GENERAL (a) The rear window defogger wires are attached to the inside of the back door glass and defog the window surface quickly when the rear window defogger switch on the air con
SEE MORE:
Lost Communication with Steering Angle Sensor Module (U0126,U0125,U0129,U0142,U0293)
DESCRIPTION These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor. HINT: If CAN communication system DTCs are stored, they may also be stored for other systems. DTC No. Detection Item DTC Detection Condition Trouble Area
Terminals Of Ecu
TERMINALS OF ECU CHECK WINDSHIELD WIPER RELAY ASSEMBLY (w/ Rain Sensor) (a) Disconnect the I56 windshield wiper relay assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconn
© 2016-2025 Copyright www.lexunx.com
