Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL BACK DOOR LOCK ASSEMBLY (BACK DOOR COURTESY SWITCH)
HINT:
- When installing a new back door lock assembly (back door courtesy switch), if there is a rope on the assembly, remove the rope before installation.
- The rope can be removed from the back door lock assembly (back door courtesy switch) by pulling either one of the 2 ends.
(a) w/o Power Back Door:
(1) Apply MP grease to the sliding parts of the back door lock assembly (back door courtesy switch).
(2) Install the back door lock assembly (back door courtesy switch) with the 3 bolts.
Torque:
13 N·m {133 kgf·cm, 10 ft·lbf}
(3) Connect the connector.
(b) w/ Power Back Door:
(1) Apply MP grease to the sliding parts of the back door lock assembly (back door courtesy switch).
(2) Install the back door lock assembly (back door courtesy switch) with the 4 bolts.
Torque:
13 N·m {133 kgf·cm, 10 ft·lbf}
(3) Connect the connector and attach the clamp.
2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
Click here .gif)
3. INSTALL BACK DOOR LOCK COVER (w/o Power Back Door)
Click here
4. INSTALL BACK DOOR LOCK COVER (w/ Power Back Door)
Click here
5. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)
Click here
6. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)
Click here
7. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)
Click here
8. INSTALL PULL HANDLE (w/ Power Back Door)
Click here
9. INSTALL BACK DOOR SIDE GARNISH LH
Click here
10. INSTALL BACK DOOR SIDE GARNISH RH
Click here
11. INSTALL CENTER BACK DOOR GARNISH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ Wireless Charger *B w/o Wireless Charger *1 CONSOLE BOX ASSEMBLY *2 CONSOLE BOX ILLUMINATION LIGHT ASSEMBLY *3 CONSOLE COMPARTMENT DOOR SUB-ASSE
Removal
REMOVAL PROCEDURE 1. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY (w/ Wireless Charger) Click here 2. REMOVE CONSOLE BOX ILLUMINATION LIGHT ASSEMBLY (w/ Wireless Charger) (a) Disconnect the connec
SEE MORE:
Vehicle Control History
VEHICLE CONTROL HISTORY NOTICE: When checking the Vehicle Control History, make sure to record the output codes. Then, clear the Vehicle Control History (RoB) and check it again. CHECK VEHICLE CONTROL HISTORY (FRONT RADAR SENSOR SYSTEM) (a) Connect the Techstream to the DLC3. (b) Turn the power swit
Components
COMPONENTS ILLUSTRATION *1 FUEL DELIVERY PIPE *2 FUEL INJECTOR ASSEMBLY *3 FUEL TUBE SUB-ASSEMBLY *4 INJECTOR VIBRATION INSULATOR *5 FUEL DELIVERY PIPE SPACER *6 O-RING *7 FUEL INJECTOR ASSEMBLY CONNECTOR *8 NO. 1 FUEL PIPE CLAMP N*m (kgf*cm, ft.*lbf):
