Lexus NX: Back Door Speaker
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/o Power Back Door *B w/ Power Back Door *C for 10 Speakers *D for 14 Speakers *1 BACK DOOR CENTER GARNISH *2 BACK DOOR FINISH COVER LH *3
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH Click here 4. REMOVE BACK DOOR TRIM BASE (w/
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR NO. 3 SPEAKER ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: for 10 Speakers Tester Connection Con
SEE MORE:
Open in Rear Floor Electrical Key Oscillator Circuit (B27A6)
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the No. 2 indoor electrical key antenna assembly (rear floor). For the No. 2 indoor electrical key antenna assembly (rear floor) to detect when the electrical key transmitter sub-assembl
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click here PROCEDURE 1. REPAIR INSTRUCTION Click here 2. INSTALL NO. 3 BLAC
© 2016-2026 Copyright www.lexunx.com
