Lexus NX: Black Screen
Lexus NX Service Manual / Audio & Visual & Telematics / Audio / Video / Audio And Visual System / Black Screen
PROCEDURE
| 1. | CHECK DISPLAY SETTING |
(a) Check that the display is not in screen off mode.
OK:
The display setting is not in screen off mode.
| NG | .gif) | CHANGE SCREEN TO SCREEN ON MODE |
|
.gif)
| 2. | CHECK IMAGE QUALITY SETTING |
(a) Check that the display settings (contrast, brightness) can be set.
OK:
Setting is possible.
| OK | | SET SCREEN COLOR QUALITY TO NORMAL |
| NG | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
.gif)
READ NEXT:
Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter
DESCRIPTION The radio receiver assembly receives a vehicle speed signal from the combination meter assembly to control the ASL function. HINT:
A voltage of 12 V or 5 V is output from each ECU and t
Steering Pad Switch Circuit
DESCRIPTION This circuit sends an operation signal from the steering pad switch assembly to the radio receiver assembly. If there is an open in the circuit, the audio system cannot be operated using t
Illumination Circuit
DESCRIPTION Power is supplied to the radio receiver assembly and steering pad switch assembly when the light control switch is in the tail or head position. WIRING DIAGRAM CAUTION / NOTICE / HINT NOT
SEE MORE:
Under Hood
General MaintenanceGENERAL MAINTENANCE PROCEDURE 1. GENERAL NOTES
Maintenance requirements vary depending on country.
Check the maintenance schedule in the owner's manual.
Following the maintenance schedule is mandatory.
Determine the appropriate time to service the vehicle using either mi
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT IGNITION CONTROL RELAY (IGCT) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage is not applied
© 2016-2025 Copyright www.lexunx.com
