Lexus NX: CAN Communication Failure (Message Registry) (U1000)
Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Lighting System (for Triple Beam Headlight) / CAN Communication Failure (Message Registry) (U1000)
DESCRIPTION
This DTC is output when an internal malfunction of the CAN communication-related ECU is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U1000 | CAN Communication Failure (Message Registry) | A headlight ECU sub-assembly LH CAN communication function malfunction is detected | Headlight ECU sub-assembly LH |
CAUTION / NOTICE / HINT
NOTICE:
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click here .gif)
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Turn the power switch on (IG).
(b) Check for DTCs.
Click here
OK:
DTC U1000 is not output.
| OK | .gif) | USE SIMULATION METHOD TO CHECK |
| NG | | REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH |
READ NEXT:
Turn Signal Switch Circuit
DESCRIPTION The combination meter receives the turn signal switch information and controls the turn signal lights. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the combination meter
Headlight Dimmer Switch Circuit
DESCRIPTION The main body ECU (multiplex network body ECU) receives light control switch signals, dimmer switch signals, fog light switch signals from the headlight dimmer switch. WIRING DIAGRAM CAUT
Daytime Running Light Relay Circuit
DESCRIPTION The illumination of the daytime running light (clearance light assembly) or clearance light is controlled by the headlight ECU sub-assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
SEE MORE:
Adjustment
ADJUSTMENT PROCEDURE 1. STEERING OFF CENTER ADJUSTMENT HINT: This is the adjustment procedure for when the steering is off-center. (a) Check if the steering wheel is off-center. (1) Apply masking tape to the top center of the steering wheel and upper steering column cover. *1 Steer
Installation
INSTALLATION PROCEDURE 1. INSTALL CLEARANCE WARNING ECU ASSEMBLY (a) Attach the 2 claws to install the clearance warning ECU assembly. 2. INSTALL ECU INTEGRATION BOX RH Click here 3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Cli
© 2016-2026 Copyright www.lexunx.com
