Lexus NX: CAN Communication Failure (Message Registry) (U1000)
Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Intuitive Parking Assist System (w/ Intelligent Clearance Sonar System) / CAN Communication Failure (Message Registry) (U1000)
DESCRIPTION
If DTC U1000 is stored frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again even if the DTC is not output when rechecking for DTCs.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U1000 | CAN Communication Failure (Message Registry) | ECU malfunction | Clearance warning ECU assembly |
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Clear the DTCs.
Click here .gif)
(b) Check for DTCs.
Click here
OK:
DTC U1000 is not output.
HINT:
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even if the DTC was not output when rechecking for DTCs.
Click here
| OK | .gif) | USE SIMULATION METHOD TO CHECK |
| NG | | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
READ NEXT:
No. 1 Clearance Warning Buzzer Circuit
DESCRIPTION This circuit consists of the No. 1 clearance warning buzzer and clearance warning ECU assembly. An ECU-excited type buzzer is used. The ECU operates the buzzers using a sound pattern that
Clearance Warning ECU Power Source Circuit
DESCRIPTION This circuit provides power to operate the clearance warning ECU assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before perf
No. 2 Clearance Warning Buzzer Circuit
DESCRIPTION This circuit consists of the No. 2 clearance warning buzzer and clearance warning ECU assembly. An ECU-excited type buzzer is used. The ECU operates the buzzers using a sound pattern that
SEE MORE:
Back Door Closer Switch Malfunction (B2251)
DESCRIPTION The multiplex network door ECU receives signals from the latch switch, initial switch, pawl switch and back door courtesy switch, which are built into the back door lock assembly. Based on these switch signals, the latch position of the back door lock assembly is determined. DTC No.
Removal
REMOVAL PROCEDURE 1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Click here 2. REMOVE COWL SIDE TRIM BOARD LH Click here 3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 4. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Click here 5. REMOVE ACCELERATION SENSOR (a) for RH side: (1) Dis
© 2016-2026 Copyright www.lexunx.com
