Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | FRONT SUSPENSION MEMBER REINFORCEMENT RH | *2 | NO. 1 ENGINE UNDER COVER ASSEMBLY |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | CRANKSHAFT PULLEY ASSEMBLY | *2 | TIMING CHAIN COVER OIL SEAL |
| *3 | CRANKSHAFT PULLEY SET BOLT | - | - |
| | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
.png) | MP grease | - | - |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. REMOVE FAN AND GENERATOR V BELT Click here 3. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH Click here 4. REMOVE C
Installation
INSTALLATION PROCEDURE 1. INSTALL TIMING CHAIN COVER OIL SEAL (a) w/o Side Lip: (1) Apply MP grease to the lip of a new timing chain cover oil seal. NOTICE:
Do not allow foreign matter to contact t
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedures listed below are for the LH side.
PROCEDURE 1. REMOVE FRONT DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH HINT: When removing the front door lower outside moulding sub-assembly LH, heat the fro
Error in Matching of ECUs (C1567)
DESCRIPTION Based on the ECM signal, the power steering ECU assembly determines if the correct type of ECM is installed. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition C1567 Error in Matching of ECUs There is a system reco
© 2016-2026 Copyright www.lexunx.com
