Lexus NX: Rear Crankshaft Oil Seal
Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (engine Mechanical) / Rear Crankshaft Oil Seal
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FLYWHEEL SUB-ASSEMBLY *2 REAR ENGINE OIL SEAL *3 TRANSMISSION INPUT DAMPER ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusab
Removal
REMOVAL PROCEDURE 1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY Click here 2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY (a) Using SST, hold the crankshaft pulley assembly. SST: 09213-54015 SST: 09
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL (a) Apply MP grease to the lip of a new rear engine oil seal. NOTICE:
Do not allow foreign matter to contact the lip of the rear engine oil se
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY *2 INSTRUMENT SIDE PANEL LH *3 INSTRUMENT SIDE PANEL RH *4 LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL *5 NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY *6 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-AS
Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the T9 sliding roof ECU (sliding roof drive gear sub-assembly) connector. (b) Measure the resistance and voltage according to the value(s) in the table below. Tester Connection Wiring Color Terminal
© 2016-2026 Copyright www.lexunx.com
