Lexus NX: 2ar-fxe (engine Mechanical)
Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (engine Mechanical)
- Camshaft
- Cylinder Block
- Cylinder Head
- Cylinder Head Gasket
- Drive Belt
- Engine
- Engine Assembly
- Engine Unit
- Front Crankshaft Oil Seal
- Rear Crankshaft Oil Seal
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 AIR CLEANER CAP SUB-ASSEMBLY *2 AIR CLEANER CASE SUB-ASSEMBLY *3 AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY *4 ENGINE WIRE *5 FAN AND GENERATOR V BELT
Removal
REMOVAL PROCEDURE 1. REMOVE SERVICE PLUG GRIP Click here 2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Click here 3. REMOVE REAR ENGINE UNDER COVER RH Click here 4. REMOVE FAN AND GENERATOR V B
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Pre-Collision System / Trouble Codes. Body Electrical > Pre-Collision System > Trouble Codes (e) Check for DTCs.
Terminals Of Ecu
TERMINALS OF ECU CHECK FORWARD RECOGNITION CAMERA NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
Do not apply larger loads than necessary since the connector may be
© 2016-2026 Copyright www.lexunx.com
