Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | DECK FLOOR BOX LH | *2 | NO. 3 DECK BOARD SUB-ASSEMBLY |
| *3 | REAR DECK FLOOR BOX | *4 | NEGATIVE AUXILIARY BATTERY TERMINAL |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | REAR DOOR ARMREST SET BRACKET LH | *2 | REAR DOOR BELT MOULDING ASSEMBLY LH |
| *3 | REAR DOOR CHECK ASSEMBLY LH | *4 | REAR DOOR FRAME GARNISH LH |
| *5 | REAR DOOR FRONT WINDOW FRAME MOULDING LH | *6 | REAR DOOR GLASS RUN LH |
| *7 | REAR DOOR GLASS SUB-ASSEMBLY LH | *8 | REAR DOOR INNER GLASS WEATHERSTRIP LH |
| *9 | REAR DOOR INSIDE HANDLE BEZEL PLUG LH | *10 | REAR DOOR REAR GUIDE SEAL LH |
| *11 | REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH | *12 | REAR DOOR REAR WINDOW FRAME MOULDING LH |
| *13 | REAR DOOR SERVICE HOLE COVER LH | *14 | REAR DOOR TRIM BOARD SUB-ASSEMBLY LH |
| *15 | REAR DOOR TRIM COVER LH | *16 | REAR DOOR UPPER WINDOW FRAME MOULDING LH |
| *17 | REAR DOOR WEATHERSTRIP LH | *18 | REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL |
| *19 | RIVET | *20 | BUTYL TAPE |
| *21 | HOLE PLUG | - | - |
| | N*m (kgf*cm, ft.*lbf): Specified torque | ★ | Precoated part |
| ● | Non-reusable part | .png) | MP grease |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. PRECAUTION NOTICE: After the power switch off
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL REAR DOOR REAR WINDOW FRAME MOULD
SEE MORE:
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
PROCEDURE 1. REMOVE STEERING LOCK ACTUATOR ASSEMBLY (a) Secure the electric power steering column sub-assembly in a vise. (b) Using a cent
Components
COMPONENTS ILLUSTRATION *1 AIR CLEANER CAP SUB-ASSEMBLY *2 AIR CLEANER CASE SUB-ASSEMBLY *3 AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY *4 HEATER ACCESSORY ASSEMBLY *5 HEATER WATER INLET HOSE A *6 HEATER WATER OUTLET HOSE A *7 FUEL VAPOR FEED HOSE *8 NO. 2 FUEL VA
