Lexus NX: Components

COMPONENTS

ILLUSTRATION

*1

AIR CLEANER CAP SUB-ASSEMBLY

*2

AIR CLEANER CASE SUB-ASSEMBLY

*3

AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

*4

HEATER ACCESSORY ASSEMBLY

*5

HEATER WATER INLET HOSE A

*6

HEATER WATER OUTLET HOSE A

*7

FUEL VAPOR FEED HOSE

*8

NO. 2 FUEL VAPOR FEED HOSE

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

READ NEXT:

 Removal

REMOVAL PROCEDURE 1. DRAIN ENGINE COOLANT (for Inverter Coolant) Click here 2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Click here 3. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY Click here 4.

 Inspection

INSPECTION PROCEDURE 1. INSPECT HEATER ACCESSORY ASSEMBLY *a Component without harness connected (Heater Accessory Assembly (Heater Water Pump)) (a) Check the motor operation. (1) Apply the p

 Installation

INSTALLATION PROCEDURE 1. INSTALL HEATER ACCESSORY ASSEMBLY (a) Connect the heater water inlet hose A with the paint mark (Blue) facing up and attach the clip within the area shown in the illustrat

SEE MORE:

 Components

COMPONENTS ILLUSTRATION *1 BLOWER ASSEMBLY - - ILLUSTRATION *1 AIR FILTER CASE *2 AIR REFINER ELEMENT *3 BLOWER WITH FAN MOTOR SUB-ASSEMBLY *4 NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY

 Disc cannot be Ejected

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur: A communication malfunction DTC may be stored. The radio receiver assembly may not

© 2016-2026 Copyright www.lexunx.com