Lexus NX: Rear Spoiler
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 BACK DOOR CENTER GARNISH *2 REAR SIDE SPOILER SUB-ASSEMBLY LH *3 REAR SIDE SPOILER SUB-ASSEMBLY RH *4 REAR SPOILER ASSEMBLY *5 HOLE PLUG - -
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE REAR SPOILER ASSEMBLY (a) Remove the 2 hole plugs. Nut Bolt Connector (b) Remove the 4 nuts. (c) Re
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE CENTER STOP LIGHT ASSEMBLY Click here 2. REMOVE REAR SPOILER NO. 2 PROTECTOR (a) Remove the 2 rear spoiler No. 2 protectors. 3. REMOVE PACKING (a) Remove the 3 packi
SEE MORE:
Freeze Frame Data
FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever an automatic headlight beam level control system DTC is stored, the headlight ECU subassembly LH stores the current vehicle state as freeze frame data. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG).
Oxygen (A/F) Sensor Heater Control Circuit Low (Bank 1 Sensor 1) (P0031,P0032,P101D)
DESCRIPTION Refer to DTC P2195. Click here HINT:
When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the air fuel ratio sensor heater in fail-safe mode. Fail-safe mode continues until the power switch is turned off.
Although the DTC titles say oxygen sensor, th
© 2016-2026 Copyright www.lexunx.com
