Lexus NX: Components

COMPONENTS

ILLUSTRATION

*A

for 8 Speakers

*B

for 10 Speakers

*C

for 14 Speakers

-

-

*1

REAR DOOR INSIDE HANDLE BEZEL PLUG LH

*2

REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

*3

REAR DOOR TRIM COVER LH

*4

REAR NO. 2 SPEAKER ASSEMBLY

*5

REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

*6

REAR SPEAKER ASSEMBLY

READ NEXT:

 Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR DOOR TRIM COVER LH Click here 2

 Inspection

INSPECTION PROCEDURE 1. INSPECT REAR SPEAKER ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: for 8 Speakers Tester Connection Condition

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL REAR NO. 2 SPEAKER ASSEMBLY NOTIC

SEE MORE:

 Turn Signal Switch Circuit

DESCRIPTION The combination meter receives the turn signal switch information and controls the turn signal lights. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the combination meter assembly, make sure to replace it with a new one. PROCEDURE 1. READ VALUE USING TECHSTREAM (TU

 Terminals Of Ecu

TERMINALS OF ECU CHECK COMBINATION METER ASSEMBLY (a) Disconnect the I10 combination meter assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table below. Tester Connection Wiring Color Terminal Description Condition Specified Condition I10-21

© 2016-2026 Copyright www.lexunx.com