Lexus NX: Components

COMPONENTS

ILLUSTRATION

*1

DECK FLOOR BOX LH

*2

NO. 3 DECK BOARD SUB-ASSEMBLY

*3

REAR DECK FLOOR BOX

*4

NEGATIVE AUXILIARY BATTERY TERMINAL

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

ILLUSTRATION

*1

CLEARANCE WARNING ECU ASSEMBLY

*2

ECU INTEGRATION BOX RH

*3

GLOVE COMPARTMENT DOOR ASSEMBLY

*4

NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

N*m (kgf*cm, ft.*lbf): Specified torque

Non-reusable part

READ NEXT:

 Removal

REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After the power switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal. Click here 2. REMOVE NO. 3

 Installation

INSTALLATION PROCEDURE 1. INSTALL CLEARANCE WARNING ECU ASSEMBLY (a) Attach the 2 claws to install the clearance warning ECU assembly. 2. INSTALL ECU INTEGRATION BOX RH Click here 3. INSTALL NO. 2 I

 Intelligent Clearance Sonar System

SEE MORE:

 Open in Driver Side Electrical Antenna Circuit (B27A1)

DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the front door outside handle assembly (for driver door) (electrical key antenna) at intervals of 0.25 seconds. For the front door outside handle assembly (for driver door) (electrical k

 DC/DC Converter Voltage Sensor "A" Low (P0E33-589,P0E34-590)

DESCRIPTION The MG ECU, which is built into the inverter with converter assembly, detects pre-boosting high voltage (VL) using the voltage sensor in the boost converter to control boosting. The MG ECU also monitors the boost converter voltage sensor signal line and detects malfunctions. DTC No.

© 2016-2023 Copyright www.lexunx.com