Lexus NX: Components
COMPONENTS
ILLUSTRATION
.png)
| *1 | NO. 1 ENGINE UNDER COVER ASSEMBLY | - | - |
ILLUSTRATION
| *1 | SHIFT LEVER POSITION SENSOR | *2 | TRANSMISSION CONTROL CABLE ASSEMBLY |
| *3 | CONTROL SHAFT LEVER | *4 | LOCK PLATE |
| *5 | WASHER | *6 | CLIP |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (a) Remove the nut and disconnect the transmission control cable assem
Inspection
INSPECTION PROCEDURE 1. INSPECT SHIFT LEVER POSITION SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specifi
Adjustment
ADJUSTMENT PROCEDURE 1. INSPECT SHIFT LEVER POSITION SENSOR POSITION (a) Apply the parking brake. (b) Lock the wheels with chocks to secure the vehicle. (c) Turn the power switch on (READY). (d) Move
SEE MORE:
Luggage Compartment Room Light
ComponentsCOMPONENTS ILLUSTRATION *1 NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY - - RemovalREMOVAL PROCEDURE 1. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side) (a) Put protective tape around the No. 1 luggage compartment light assembly. Protective Tape (b) Using
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH (a) Measure the resistance according to the value(s) in the table below. *1 Connector A *2 Connector B *3 Connector C - - *a Component without harness connected (Front Seat Inner Belt Assembly LH) - -
© 2016-2026 Copyright www.lexunx.com
