Lexus NX: Console Box Light
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ Wireless Charger *B w/o Wireless Charger *1 CONSOLE BOX ASSEMBLY *2 CONSOLE BOX ILLUMINATION LIGHT ASSEMBLY *3 CONSOLE COMPARTMENT DOOR SUB-ASSE
Removal
REMOVAL PROCEDURE 1. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY (w/ Wireless Charger) Click here 2. REMOVE CONSOLE BOX ILLUMINATION LIGHT ASSEMBLY (w/ Wireless Charger) (a) Disconnect the connec
Inspection
INSPECTION PROCEDURE 1. INSPECT CONSOLE BOX ILLUMINATION LIGHT ASSEMBLY (a) Apply battery voltage to the connector and check the light illumination condition. OK: Measurement Condition Specif
SEE MORE:
Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136. Click here HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the power switch is turned off. DTC No. Detection Item DTC Detection Condi
System Description
SYSTEM DESCRIPTION WIRELESS DOOR LOCK CONTROL SYSTEM The wireless door lock control system can be used to lock and unlock all doors from a distance. The system is controlled by an electrical key transmitter sub-assembly which sends radio waves to the door control receiver. The certification ECU (sma
© 2016-2026 Copyright www.lexunx.com
