Lexus NX: Cruise Control Input Circuit (P0575)
DESCRIPTION
When the hybrid vehicle control ECU detects an internal malfunction, DTC P0575 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| P0575 | Cruise Control Input Circuit | Detection Condition1
Detection Condition2
| Hybrid vehicle control ECU | Radar Cruise1 |
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the hybrid vehicle control ECU, refer to Service Bulletin.
PROCEDURE
| 1. | CHECK FOR DTCs (Radar Cruise1) |
(a) Clear the DTCs.
Click here .gif)
(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
(c) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| DTC P0575 is not output. | A |
| DTC P0575 is output. | B |
| A | .gif) | USE SIMULATION METHOD TO CHECK |
| B | | REPLACE HYBRID VEHICLE CONTROL ECU |
READ NEXT:
Brake System (P1578)
DESCRIPTION When a malfunction in the electronically controlled brake system is detected, DTC P1578 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
Communication Error from VSC to HV ECU (P1630)
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) sends signals such as brake request signals to the hybrid vehicle control ECU. If an abnormal signal is detected, the hyb
Lost Communication with Cruise Control Module (U0104,U0122,U0293)
DESCRIPTION The hybrid vehicle control ECU communicates with each sensor and ECU via CAN communication. If any malfunction is detected in a CAN communication circuit, one or more CAN communication sys
SEE MORE:
Registered Device cannot be Deleted
PROCEDURE 1. DELETE OPERATION (a) Check if a registered portable player can be deleted normally. OK: Registered portable player can be deleted normally. OK END NG PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136. Click here HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the power switch is turned off. DTC No. Detection Item DTC Detection Condi
