Lexus NX manuals

Lexus NX: Cursor or Map Rotates when Vehicle Stopped

Lexus NX Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System / Cursor or Map Rotates when Vehicle Stopped

PROCEDURE

1.

CHECK CONDITION

(a) Check with the customer if the vehicle has been turned by a turntable.

OK:

Vehicle has not been turned by a turntable.

HINT:

If the vehicle is turned on a turntable with the power switch on (IG), the system may store the angular velocity. As a result, the vehicle position cursor may deviate. In this case, the vehicle position cursor will return to normal by turning the power switch off and back to on (IG) again with the vehicle completely stopped.
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

TURN POWER SWITCH ON (IG) WHEN VEHICLE IS COMPLETELY STOPPED

READ NEXT:

 "No GPS signal" mark is displayed

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following

 Voice Guidance does not Function

WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was

 Route cannot be Calculated

PROCEDURE 1. SET DESTINATION (a) Set another destination and check if the system can calculate the route correctly. OK: Route can be correctly calculated. OK NORMAL OPERATION NG

SEE MORE:

 Reassembly

REASSEMBLY PROCEDURE 1. INSTALL ENGINE HOOD LOCK STRIKER ASSEMBLY (a) Attach the guide. (b) Install the engine hood lock striker assembly with the 2 bolts. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} 2. INSTALL RADIATOR SUPPORT OPENING COVER Click here 3. INSTALL HOOD AUXILIARY CATCH HOOK ASSEMBL

 Disassembly

DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: Do not try to remove the black nylon tube as it is welded to the fuel suction tube assembly. Click here PROCEDURE 1. REMOVE NO. 1 FUEL SUB-TANK (a) Disconnect the fuel pump harness connector. (b) Using needle nose pliers, remove the fuel

© 2016-2026 Copyright www.lexunx.com