Lexus NX manuals

Lexus NX: Reassembly

Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Headlight Assembly (for Triple Beam Headlight) / Reassembly

REASSEMBLY

CAUTION / NOTICE / HINT

NOTICE:

  • Handle components indoors as much as possible to prevent foreign matter from entering and adhering to headlight assembly components.
  • Do not reuse parts which have reduced fastening ability due to thread damage.
  • When installing components, make sure that the wire harness is not pinched or pulled.
  • Do not use solvent to clean components. Only clean them with a dry cloth.

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL HEADLIGHT GASKET

Click here

2. INSTALL HEADLIGHT ECU SUB-ASSEMBLY LH

Click here

READ NEXT:

 Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL HEADLIGHT ASSEMBLY LH (a) Conn

 Repair

REPAIR CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. If the installation area of the headlight assembly is damaged

 Headlight Assembly(for Single Beam Headlight)

SEE MORE:

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be dis

 Cooling Fan Ecu

On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COOLING FAN ECU (a) Check and ensure the following conditions: (1) The power switch is off. (2) The engine coolant temperature is less than 92°C (198°F). (3) The auxiliary battery voltage is between 11 and 14 V. (4) The A/C switch is

© 2016-2026 Copyright www.lexunx.com