Lexus NX: Removal
REMOVAL
PROCEDURE
1. REMOVE STEERING PAD
Click here .gif)
2. REMOVE CRUISE CONTROL MAIN SWITCH
Click here
3. REMOVE STEERING PAD SWITCH ASSEMBLY
| (a) Disconnect the connector from the spiral cable with sensor sub-assembly. |
|
(b) Remove the 2 screws.
(c) Detach the 3 guide pins and 4 claws and remove the switch assembly.
READ NEXT:
Inspection
INSPECTION PROCEDURE 1. INSPECT STEERING PAD SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. *A w/ Lane Departure Alert System - - *1 SEEK+ *
Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING PAD SWITCH ASSEMBLY (a) Engage the 4 claws and 3 guide pins to install the steering pad switch assembly to the steering wheel sub-assembly. (b) Install the 2
SEE MORE:
If a warning light turns on or a warning
buzzer sounds
Calmly perform the following actions if any of the warning lights comes
on or
flashes. If a light comes on or flashes, but then goes off, this does not
necessarily
indicate a malfunction in the system. However, if this continues to occur,
have the vehicle inspected by your Lexus dealer.
Acti
Radio Broadcast cannot be Received or Poor Reception
WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver a
© 2016-2026 Copyright www.lexunx.com
