Lexus NX: Customize Parameters
CUSTOMIZE PARAMETERS
Drive Mode Customization
"Custom" settings can be changed on the screen of the multi-display.
HINT:
"Custom" mode can be selected by using the drive mode select switch (integration control and panel assembly).
(a) Turn the power switch on (IG).
(b) Select the following menus: Setup / Vehicle / DRIVE MODE CUSTOMIZATION
DRIVE MODE CUSTOMIZATION
| Display | Content | Default | Setting |
| POWER TRAIN | Acceleration response, etc. | NORMAL | POWER / NORMAL / ECO |
| CHASSIS | Damping force of suspension, steering assist force, VDIM control, etc. | NORMAL | SPORT / NORMAL / COMFORT |
| CLIMATE | Effectiveness of air conditioning system, etc. | NORMAL | NORMAL / ECO |
READ NEXT:
TEST MODE PROCEDURE TEST MODE PROCEDURE NOTICE:
After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification infor
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
TERMINALS OF ECU CHECK ABSORBER CONTROL ECU *a Component with harness connected (Absorber Control ECU) - - HINT:
Inspect the connectors from the back side while the connectors are conn
SEE MORE:
DESCRIPTION The main body ECU (multiplex network body ECU) receives a door open or closed signal from each door courtesy light switch. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Recognition code registration is necessary when replacing the main body ECU (multiplex network body ECU).
If the
DESCRIPTION The rear center ultrasonic sensor (RRC sensor) is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear center ultrasonic sensor (RRC sensor). If the rear center ultrasonic sensor (RRC sensor) has an open circuit or oth
© 2016-2026 Copyright www.lexunx.com
