Lexus NX: Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZING WITH MULTI-DISPLAY
(a) Turn the power switch on (IG).
(b) Time zone setting
(1) Using the multi-display, select "Setup", "General", "Clock", and then time zone and change the customize setting.
| Item | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Time Zone | Auto | Setting for clock time zone | Pacific/Mountain/Eastern/Atlantic/Newfoundland/Hawaii/Alaska/Central/Other/Auto | Radio receiver assembly |
HINT:
If "Auto" is selected, the time zone will automatically be selected by the current vehicle position.
(c) Daylight saving time setting
(1) Using the multi-display, select "Setup", "General", "Clock", and then daylight saving time and change the customize setting.
| Item | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Daylight Saving Time | ON | Setting for clock daylight saving time | ON/OFF | Radio receiver assembly |
(d) Auto adjust by GPS setting
(1) Using the multi-display, select "Setup", "General", "Clock", and then auto adjust by GPS and change the customize setting.
| Item | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Auto Adjust by GPS | On | Setting for clock auto adjust by GPS | ON/OFF | Radio receiver assembly |
HINT:
- If "ON" is selected, the clock will automatically be adjusted by the clock function of navigation system.
- If "OFF" is selected, the clock can be manually adjusted.
(e) Manual clock setting
(1) Using the multi-display, select "Setup", "General", "Clock", select "auto adjust by GPS" to "OFF" and then hours and change the customize setting.
| Item | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Hours | - | Setting for manual clock adjustment of hour | -/+/AM/PM | Radio receiver assembly |
(2) Using the multi-display, select "Setup", "General", "Clock", select "auto adjust by GPS" to "OFF" and then minutes and change the customize setting.
| Item | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Minutes | - | Setting for manual clock adjustment of minute | -/+/:00 | Radio receiver assembly |
HINT:
If ":00" is selected, the minute value will be rounded up or down to the nearest hour.
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
Terminals Of Ecu
TERMINALS OF ECU CLOCK ASSEMBLY Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition I163-1 (ILL-) - Body ground G - Body ground Illumination signa
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL WINDSHIELD WASHER JAR ASSEMBLY (w/ Headlight Cleaner System) (a) Install the level warning switch assembly as shown in the illustration. NOTICE: Make sure that the protrusion of the level warning switch assembly is between the 2 markings. *a Protru
Operation Check
OPERATION CHECK CHECK BASIC OPERATION NOTICE:
This check is possible only when the "Power Back Door Function" customization setting using the multi-information display in the combination meter assembly is set to ON (initial setting is ON).
Click here
Before performing an operation check, chec
