Lexus NX: Clock System
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 CLOCK ASSEMBLY *2 COMBINATION METER ASSEMBLY *3 RADIO RECEIVER ASSEMBLY *4 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - ACC FUSE - PANEL FUSE *5
System Diagram
SYSTEM DIAGRAM
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedures to troubleshoot the clock system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2
SEE MORE:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
w
Inspection Mode Procedure
INSPECTION MODE PROCEDURE NOTICE: When operating the vehicle in inspection mode for an operation such as a speedometer test, a DTC may be set. Therefore, if the warning light comes on, after canceling inspection mode, check for DTCs using the Techstream and clear the DTCs. HINT:
If the engine is
© 2016-2026 Copyright www.lexunx.com
