Lexus NX: Data Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit.
WIRING DIAGRAM
.png)
PROCEDURE
| 1. | CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
| (a) Disconnect the I179 radio receiver assembly connector. |
|
.png)
(b) Disconnect the I166 No. 1 stereo jack adapter assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I179-2 (US1-) - I166-2 (UDO-) | Always | Below 1 Ω |
| I179-3 (US1+) - I166-3 (UDO+) | Always | Below 1 Ω |
| I179-5 (USG1) - I166-5 (UJSS) | Always | Below 1 Ω |
| I179-2 (US1-) or I166-2 (UDO-) - Body ground | Always | 10 kΩ or higher |
| I179-3 (US1+) or I166-3 (UDO+) - Body ground | Always | 10 kΩ or higher |
| I179-5 (USG1) or I166-5 (UJSS) - Body ground | Always | 10 kΩ or higher |
| OK | .gif) | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
.gif)
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
READ NEXT:
Mute Signal Circuit between Stereo Component Amplifier and Telematics Transceiver
DESCRIPTION This DCM (telematics transceiver) sends a mute signal to the stereo component amplifier assembly. The stereo component amplifier assembly controls the volume according to the mute signal f
AVC-LAN Circuit
DESCRIPTION Each audio system component connected to the AVC-LAN (communication bus) transfers switch signals using the audio visual communication local area network. If a short to +B or short to grou
Vehicle Speed Signal Circuit between Navigation ECU and Combination Meter
DESCRIPTION The navigation ECU receives a vehicle speed signal from the combination meter assembly. HINT:
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter as
SEE MORE:
Inspection
INSPECTION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSPECT REAR STABILIZER LINK ASSEMBLY LH NOTICE: Since the rear stabilizer link, rear stabilizer cushions and lock nut are not reusable, new p
System Diagram
SYSTEM DIAGRAM *1 ECM *2 Engine Coolant Temperature Sensor *3 Air Fuel Ratio Sensor (for Bank 1 Sensor 1) *4 Heated Oxygen Sensor (for Bank 1 Sensor 2) *5 Crankshaft Position Sensor *6 Intake Manifold *7 Manifold Absolute Pressure Sensor *8 EGR Valve Assembly
