Lexus NX: Diagnosis System
Lexus NX Service Manual / Vehicle Interior / Seat Belt / Seat Belt Warning System / Diagnosis System
DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here .gif)
INSPECT AUXILIARY BATTERY VOLTAGE
(a) Measure the auxiliary battery voltage.
Standard voltage:
11 to 14 V (power switch off)
If the voltage is below 11 V, recharge or replace the auxiliary battery.
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether
Driver Side Seat Belt Warning Light does not Operate
DESCRIPTION The combination meter assembly illuminates, blinks or turns off the front seat belt warning light on the combination meter assembly in accordance with the state of the front seat inner bel
Front Passenger Side Seat Belt Warning Light Malfunction
DESCRIPTION When the power switch is turned on (IG), the occupant detection ECU sends a signal to the airbag ECU assembly to indicate the state of the front seat inner belt assembly RH and also whethe
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR NOTICE:
The steering lock ECU (steering lock actuator assembly) does not store history DTCs. If any DTCs are output, confirm and record them as soon as possible. Do not turn the power switch off or clear the DTCs until the DTCs are confirmed and recorded.
DTCs may have been st
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: Do not allow any dirt (fingerprints, grease, etc.) to adhere to the meter glass. If the glass is dirty, wipe it clean with a soft cloth. PROCEDURE 1. REMOVE COMBINATION METER GLASS (a) Using a screwdriver, detach the 8 claws and remove the combination m
© 2016-2026 Copyright www.lexunx.com
