Lexus NX: Seat Belt Warning System
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Data List / Active Test
- Driver Side Seat Belt Warning Light does not Operate
- Front Passenger Side Seat Belt Warning Light Malfunction
- Rear Seat Belt Warning Light Malfunction
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 AIRBAG ECU ASSEMBLY *2 PARKING BRAKE ECU ASSEMBLY *3 AIR CONDITIONING CONTROL ASSEMBLY *4 HYBRID VEHICLE CONTROL ECU *5 BRAKE BOOSTER WITH MAST
System Diagram
SYSTEM DIAGRAM
System Description
SYSTEM DESCRIPTION SEAT BELT WARNING SYSTEM DESCRIPTION HINT: The front seat belt warning light on the combination meter assembly is used for both the driver side seat and front passenger side seat. (
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL TILT AND TELESCOPIC SWITCH (a) Attach the claw to install the tilt and telescopic switch. (b) Connect the connector. 2. INSTALL LOWER STEERING COLUMN COVER (a) Attach the 2 claws to install the lower steering column cover. NOTICE: Do not damage the tilt and telescop
Terminals Of Ecu
TERMINALS OF ECU CHECK WINDSHIELD WIPER RELAY ASSEMBLY (w/ Rain Sensor) (a) Disconnect the I56 windshield wiper relay assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconn
© 2016-2026 Copyright www.lexunx.com
