Lexus NX: Diagnostic Trouble Code Chart
Lexus NX Service Manual / Vehicle Exterior / Sliding Roof / Convertible / Sliding Roof System / Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Sliding Roof System| DTC No. | Detection Item | Link |
|---|---|---|
| B2341 | Sensor (Motor) Failure | |
| B2342 | Switch Failure | |
| B2343 | Position Initialization Incomplete | |
| B2344 | Position Failure | |
.gif)
READ NEXT:
Sensor (Motor) Failure (B2341,B2344)
DESCRIPTION When the sliding roof drive gear sub-assembly (sliding roof ECU) detects a motor malfunction and the sliding roof operation is stopped, DTC B2341 is stored. When the sliding roof drive gea
Switch Failure (B2342)
DESCRIPTION This DTC is stored when the sliding roof drive gear sub-assembly (sliding roof ECU) detects that the map light assembly (slide roof switch) is stuck for 30 seconds or more. DTC No. De
Position Initialization Incomplete (B2343)
DESCRIPTION This DTC is stored when the sliding roof drive gear sub-assembly (sliding roof ECU) has not been initialized. DTC No. Detection Item DTC Detection Condition Trouble Area B2343
SEE MORE:
Diagnosis System
DIAGNOSIS SYSTEM DIAGNOSIS SYSTEM (a) DTCs (normal mode) (1) DTCs are stored in the absorber control ECU and output by using the Techstream. Refer to the DTC check procedure. Click here (b) Test mode (1) By switching from normal mode to test mode, it is possible to inspect the front acceleration s
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL NO. 1 MOULDING TAPE (a) Clean the No. 1 moulding tape installation surface with a non-residue solvent. (b) Apply primer to the No. 1 mo
© 2016-2026 Copyright www.lexunx.com
