Lexus NX: Sliding Roof System
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Sensor (Motor) Failure (B2341,B2344)
- Switch Failure (B2342)
- Position Initialization Incomplete (B2343)
- Remote Control System does not Operate
- Key-off Operation Function Operates even if Operating Conditions are not Satisfied
- Sliding Roof does not Move by Operating Sliding Roof Control Switch
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *2 MAP LIGHT ASSEMBLY *3 SLIDE ROOF SWITCH *4 SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY
- SLIDING ROOF ECU
System Diagram
SYSTEM DIAGRAM
System Description
SYSTEM DESCRIPTION SLIDING ROOF SYSTEM DESCRIPTION (a) The sliding roof system controls the sliding roof operation using the sliding roof drive gear sub-assembly (sliding roof ECU). Operating the map
SEE MORE:
Steering Angle Sensor Unusual Bank Angle Detected (C1440)
DESCRIPTION If the skid control ECU (brake booster with master cylinder assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake booster with master cylinder assembly) stores DTC C1440 while VSC operation is temporarily disabled. This is not a malfunct
Open in One Side of Bus 5 Branch Line
DESCRIPTION When the CAN bus main lines are normal (no open, short to ground, short to +B or short between lines) and there is an ECU or sensor on the "Communication Bus Check" screen that is indicated as not communicating or whose connection status on the "Communication Bus Check" screen changes in
© 2016-2026 Copyright www.lexunx.com
