Lexus NX: Disposal
DISPOSAL
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH
| (a) Position the front shock absorber assembly so that it is level with the piston rod fully extended. Using a drill, make a hole in the cylinder between A and B shown in the illustration to discharge the gas inside. CAUTION: Be careful when drilling as shards of metal may fly about. Always use proper safety equipment. NOTICE: The gas is colorless, odorless and non-poisonous. |
|
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH *2 FRONT STABILIZER BAR *3 FRONT STABILIZER BAR BUSHING LH *4 FRONT STABILIZER BAR BUSHING RH *5 F
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY Click here 2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH (a) Remove the nut and front stabilizer link assembly LH. HINT: If the
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY *2 FRONT FENDER TO COWL SIDE SEAL LH *3 FRONT FENDER TO COWL SIDE SEAL RH *4 FRONT WIPER ARM HEAD CAP *5 FRONT WIPER ARM LH *6 FRONT WIPER ARM RH *7 NO. 1 WINDSHIELD OUTSIDE MOULDING CLIP *8 WI
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. INSTALL FOG LIGHT ASSEMBLY LH (a) Install the fog light assembly LH with the 3 screws. (b) Attach each hose clamp. *A LH Side *B
© 2016-2026 Copyright www.lexunx.com
