Lexus NX: Front Stabilizer Bar
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH *2 FRONT STABILIZER BAR *3 FRONT STABILIZER BAR BUSHING LH *4 FRONT STABILIZER BAR BUSHING RH *5 F
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY Click here 2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH (a) Remove the nut and front stabilizer link assembly LH. HINT: If the
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT STABILIZER LINK ASSEMBLY LH (a) Inspect the turning torque of the ball joint. (1) Secure the front stabilizer link assembly in a vise using aluminum plates. (2
SEE MORE:
Parts Location
PARTS LOCATION ILLUSTRATION *1 AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) *2 CHARCOAL CANISTER ASSEMBLY *3 EGR VALVE ASSEMBLY *4 FUEL TANK CAP ASSEMBLY *5 HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) *6 PCV VALVE *7 PURGE VSV *8 NO. 1 ENGINE ROOM RELAY BLOCK AN
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE REAR SPOILER ASSEMBLY (a) Remove the 2 hole plugs. Nut Bolt Connector (b) Remove the 4 nuts. (c) Remove the 2 bolts. (d) Disconnect the 2 connectors. (e) Put protective tape around the rear spoile
© 2016-2026 Copyright www.lexunx.com
