Lexus NX: Dtc Check / Clear

DTC CHECK / CLEAR

CHECK FOR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / AFS / Trouble Codes.

Body Electrical > AFS > Trouble Codes

(e) Check for DTCs.

CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / AFS / Clear DTCs.

Body Electrical > AFS > Clear DTCs

(e) Clear the DTCs.

READ NEXT:

 Fail-safe Chart

FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) Headlight ECU sub-assembly (1) The headlight ECU sub-assembly stops light operation if the following malfunctions are detected. Malfunction Multi-informatio

 Freeze Frame Data

FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever an automatic headlight beam level control system DTC is stored, the headlight ECU subassembly LH stores the current vehicle state as freeze frame data.

 Data List / Active Test

DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul

SEE MORE:

 Removal

REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read precaution thoroughly before servicing. Click here 2. REMOVE REAR WHEEL (for LH Side) Click here 3. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH Click here 4. REMOVE REAR BUMPER SIDE SEAL LH (a) Remove the 2 clips and rear bumper s

 Front Airbag Sensor Lost Communication (RH) (B1612,B1613)

DESCRIPTION The front airbag sensor RH circuit consists of the airbag ECU assembly and front airbag sensor RH. The front airbag sensor RH detects impacts to the vehicle and sends signals to the airbag ECU assembly to determine if the airbag should be deployed. DTC B1612 or B1613 is stored when a mal

© 2016-2026 Copyright www.lexunx.com