Lexus NX: Automatic Headlight Beam Level Control System (for Triple Beam Headlight)
Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Automatic Headlight Beam Level Control System (for Triple Beam Headlight)
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Fail-safe Chart
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Speed Sensor Malfunction (B2415)
- Height Control Sensor Malfunction (B2416,B241A)
- Headlight Beam Level Control Motor LH Malfunction (B2417,B2418)
- Headlight Leveling Motor LH Communication Malfunction (B2424,B2410,B2411,B2425)
- Initialization has not been Performed (B2450)
- Height Control Sensor Data Out of Range When Initializing (B2452)
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH *2 BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (SKID CONTROL ECU) *3 HEADLIGHT ASSEMBLY LH - HEADLIGHT ECU SUB
System Diagram
SYSTEM DIAGRAM
System Description
SYSTEM DESCRIPTION AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL (a) General The automatic headlight beam level control system ensures forward visibility and prevents dazzling of drivers in oncoming and prec
SEE MORE:
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL FRONT DOOR UPPER OUTSIDE MOULDING PAD (a) When using a new front door upper outside moulding sub-assembly LH: (1) Clean the surface of
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL (a) Apply MP grease to the lip of a new rear engine oil seal. NOTICE:
Do not allow foreign matter to contact the lip of the rear engine oil seal.
Do not allow MP grease to contact the dust seal.
(b) Using SST and a hammer, tap in the
© 2016-2026 Copyright www.lexunx.com
