Lexus NX: Dtc Check / Clear
Lexus NX Service Manual / Vehicle Exterior / Sliding Roof / Convertible / Sliding Roof System / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes.
Body Electrical > Sliding Roof > Trouble Codes(e) Check the details of the DTC(s).
Click here .gif)
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes.
Body Electrical > Sliding Roof > Clear DTCs(e) Clear the DTCs.
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Sliding Roof System DTC No. Detection Item Link B2341 Sensor (Motor) Failure B2342 Switch Failure B2343 Position Initialization Incompl
Sensor (Motor) Failure (B2341,B2344)
DESCRIPTION When the sliding roof drive gear sub-assembly (sliding roof ECU) detects a motor malfunction and the sliding roof operation is stopped, DTC B2341 is stored. When the sliding roof drive gea
SEE MORE:
Fuel Sender Gauge Assembly
ComponentsCOMPONENTS ILLUSTRATION *1 FUEL SENDER GAUGE ASSEMBLY - - N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. REMOVE FUEL TANK ASSEMBLY Click here 2. REMOVE FUEL SENDER GAUGE ASSEMBLY (a) Remove the 5 screws and fuel sender gauge assembly
System Diagram
SYSTEM DIAGRAM Communication Table Sender Receiver Signal Communication Line Air conditioning amplifier assembly Hybrid vehicle control ECU Heater idle up request signal CAN ECO mode switch information signal Engine ON request signal Charging control inhibit sign
© 2016-2026 Copyright www.lexunx.com
