Lexus NX: Freeze Frame Data
Lexus NX Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System / Freeze Frame Data
FREEZE FRAME DATA
CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
Body Electrical > Navigation System > Trouble Codes(e) Select a DTC to display its freeze frame data.
LIST OF FREEZE FRAME DATA
(a) Refer to Data List / Active Test.
Click here .gif)
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a pa
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Navigation System DTC No. Detection Item Link B1323 Lost Communication with Haptic Device B1324 Lost Communication with Meter B1325 Los
Lost Communication with Haptic Device (B1323-B1326)
DESCRIPTION These DTCs are stored when communication between the radio receiver assembly and remote operation controller assembly (remote touch), combination meter assembly, combination meter mirror E
SEE MORE:
Calibration
CALIBRATION DESCRIPTION (a) After replacing any VSC related components or performing wheel alignment adjustment, clear and read the sensor calibration data. Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration. Part
Inspection
INSPECTION PROCEDURE 1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH (a) Check the operation of the mirror surface. (1) Disconnect the outer rear view mirror assembly LH connector. *a Component without harness connected (Outer Rear View Mirror Assembly LH) (2) Apply auxiliar
© 2016-2026 Copyright www.lexunx.com
