Lexus NX: Front Camera Internal Circuit (C2A60)
Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Panoramic View Monitor System / Front Camera Internal Circuit (C2A60)
DESCRIPTION
This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the front television camera assembly via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C2A60 | Front Camera Internal Circuit | A signal indicating a malfunction in the front television camera assembly is detected. | Front television camera assembly |
CAUTION / NOTICE / HINT
NOTICE:
-
When "!" mark is displayed on the multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click here
.gif)
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
OK:
DTC C2A60 is not output.
| OK | .gif) | END |
| NG | | REPLACE FRONT TELEVISION CAMERA ASSEMBLY |
READ NEXT:
Side Camera LH Internal Circuit (C2A61)
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly LH via CAN communication. DTC No. Detection Item DTC
Side Camera RH Internal Circuit (C2A62)
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly RH via CAN communication. DTC No. Detection Item DTC
Back Camera Internal Circuit (C2A63)
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the rear television camera assembly via CAN communication. DTC No. Detection Item DTC Det
SEE MORE:
Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136. Click here HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the power switch is turned off. DTC No. Detection Item DTC Detection Condi
Poor Sound Quality in All Modes (Low Volume)
PROCEDURE 1. CHECK AUDIO SETTINGS (a) Set treble, middle and bass to the initial values and check that the sound is normal. OK: The sound returns to normal. HINT: Sound quality adjustment measures vary according to the type of amplifier. OK END
NG 2. COMPARE
© 2016-2026 Copyright www.lexunx.com
