Lexus NX: Front Door Speaker
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for 8 Speakers *B for 10 Speakers *C for 14 Speakers - - *1 FRONT DOOR INSIDE HANDLE BEZEL PLUG LH *2 FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE FRONT DOOR TRIM COVER LH Click here
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: for 8 Speakers Tester Connection Con
SEE MORE:
Collision has been detected or Collision Sensor Connection (Open) (P1606-308,P1606-317)
DTC SUMMARY MALFUNCTION DESCRIPTION The hybrid vehicle control ECU and airbag ECU detect that a collision has occurred and shut off the system main relay. The cause of this DTC may be one of the following:
Collision is detected
Detection sensor system malfunction
Airbag system malfunction
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Turn the Techstream on. (c) Put the engine in inspection mode (maintenance mode). Click here (d) Start the engine. (e) Warm up the engine. (f) Enter the following menus
© 2016-2026 Copyright www.lexunx.com
