Lexus NX: Front Suspension Member
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 FRONT CENTER FLOOR COVER LH *2 NO. 1 ENGINE UNDER COVER ASSEMBLY *3 REAR ENGINE UNDER COVER LH *4 REAR ENGINE UNDER COVER RH ILLUSTRATION *1 FRO
Removal
REMOVAL PROCEDURE 1. FRONT WHEELS FACING STRAIGHT AHEAD 2. SECURE STEERING WHEEL Click here 3. REMOVE COLUMN HOLE COVER SILENCER SHEET Click here 4. DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT AS
Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT STABILIZER BAR Click here 2. INSTALL FRONT SUSPENSION MEMBER BRACE Click here 3. TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH (a) Te
SEE MORE:
Terminals Of Ecu
TERMINALS OF ECU HINT: Perform the inspection from the harness side with the connectors connected. STEERING HEATER AND VIBRATION ECU (a) Measure the voltage or resistance according to the value(s) in the table below. Terminal No. (Symbol) Terminal Description Condition Specified Condition
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
I
© 2016-2026 Copyright www.lexunx.com
