Lexus NX: How To Proceed With Troubleshooting

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP

NEXT

2.

CONFIRM PROBLEM SYMPTOMS

NEXT

3.

CUSTOMER PROBLEM ANALYSIS

(a) Check if the vehicle has been jump started due to a discharged auxiliary battery.

Result

Proceed to

The vehicle has never been jump started.

A

The vehicle has been jump started due to a discharged auxiliary battery.

B

B

GO TO ON-VEHICLE INSPECTION / CHECK AUXILIARY BATTERY VOLTAGE

A

4.

CAN COMMUNICATION SYSTEM CHECK

(a) Using the Techstream, display the CAN Bus Check screen and check that all ECUs and sensors that are connected to the CAN communication system are displayed on the screen.

NG

GO TO CAN COMMUNICATION SYSTEM

OK

5.

CHECK FOR DTCS

Result

Proceed to

DTCs are not output

A

DTCs are output

B

B

GO TO DTC CHART

A

6.

ON-VEHICLE INSPECTION

Result

Proceed to

Malfunctioning area has not been determined

A

Malfunctioning area has been determined

B

B

GO TO STEP 8

A

7.

CHECK FOR INTERMITTENT PROBLEMS

NEXT

8.

REPAIR OR REPLACE

NEXT

END

READ NEXT:

 On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. CHECK AUXILIARY BATTERY (a) Check that the auxiliary battery cables are connected to the correct terminals. HINT: If they are not, connect them properly. (b) Check t

 Networking

 Can Communication System

SEE MORE:

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK DTC (a) Turn the power switch off. (b) Connect the Techstream to the DLC3. (c) Turn the power switch on (IG). (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / (desired system) / Trouble Codes. Body Electrical > Master Switch > Trouble Codes B

 On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT NOTICE: If using a dropper to adjust the fluid amount, make sure that the dropper has not been used with mineral oils, water or deteriorated brake fluid. Sealed areas may deteriorate and lead to fluid leaks, or the fluid may deteriorate and lead to decre

© 2016-2026 Copyright www.lexunx.com