Lexus NX: Initialization
Lexus NX Service Manual / Vehicle Interior / Heating / Air Conditioning / Air Conditioning System / Initialization
INITIALIZATION
INITIALIZATION SERVO MOTOR
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Press the A/C OFF switch.
(e) Turn the Techstream on.
(f) Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initialization.
(g) According to the Techstream display, perform servo motor initialization.
Body Electrical > Air Conditioner > Utility| Tester Display |
|---|
| Servomotor Initialization |
HINT:
During initialization, the A/C AUTO indicator light comes on, and then goes off when initialization has finished.
(h) According to the Techstream display, select the "Exit" switch to finish initialization.
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
If the auxiliary battery voltage is low, the PTC heater, seat heater system (w/ Seat Heater System) and climate control seat system (w/ Climate Control Seat System) m
Dtc Check / Clear
DTC CHECK / CLEAR DTC CHECK USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Air
Terminals Of Ecu
TERMINALS OF ECU AIR CONDITIONING AMPLIFIER ASSEMBLY (a) Disconnect the I50 air conditioning amplifier assembly connector. (b) Measure the resistance and voltage according to the value(s) in the tabl
SEE MORE:
Hybrid Battery Pack Sensor Module (P0AFC-150)
DESCRIPTION The hybrid vehicle control ECU alerts the driver and performs fail-safe control based on error signals sent from the battery voltage sensor. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P0AFC-150 Hybrid Battery Pack Sensor Module A
Terminals Of Ecu
TERMINALS OF ECU CHECK FORWARD RECOGNITION CAMERA NOTICE: DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed. (a) Measure the voltage and resistance according to the value(s) in the
© 2016-2026 Copyright www.lexunx.com
