Lexus NX: Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR SHOCK ABSORBER ASSEMBLY LH
(a) Compress and extend the shock absorber rod and check that there is no abnormal resistance or unusual sound during operation.
If there is any abnormality, replace the shock absorber with a new one.
NOTICE:
When disposing of the shock absorber, refer to the Disposal procedures (Click here .gif)
).
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. TEMPORARILY INSTALL REAR NO. 1 SHOCK ABSO
Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY LH *A w/o AVS *B w/ AVS (a) Extend the piston rod and secure the rear shock absorber assembly at an angle in a vise. (b) Us
SEE MORE:
Disposal
DISPOSAL PROCEDURE 1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY LH *A w/o AVS *B w/ AVS (a) Extend the piston rod and secure the rear shock absorber assembly at an angle in a vise. (b) Using a drill, make a hole in the cylinder between A and B shown in the illustration to discharge the
Front Right Seat Heat Sensor Circuit (B14C0)
DESCRIPTION Output to the front seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change. DTC No. Detection Item DTC Detection Condition Trouble Are
© 2016-2026 Copyright www.lexunx.com
