Lexus NX: Rear Stabilizer Bar
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 REAR NO. 1 STABILIZER BAR BRACKET *2 REAR STABILIZER BAR *3 REAR STABILIZER BUSHING *4 REAR STABILIZER LINK ASSEMBLY LH *5 REAR STABILIZER LINK ASS
Removal
REMOVAL PROCEDURE 1. REMOVE REAR STABILIZER LINK ASSEMBLY LH (a) Remove the 2 nuts and 2 cushions and disconnect the rear stabilizer link assembly LH from the rear No. 2 suspension arm assembly LH.
Inspection
INSPECTION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSPECT REAR STABILIZER LINK ASSEMBLY LH N
SEE MORE:
Drive Motor "B" Control Module (P0A1C-693,P0A1C-812)
DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate that a large current flowed in the inverter for the rear motor. The cause of this malfunction may be one of the following: Internal inverter malfunction
Internal circuit malfunction in the inverter for the rear motor
Malfunction in ECU tha
Drive Motor "A" Performance (P0A90-251)
DTC SUMMARY MALFUNCTION DESCRIPTION This DTC indicates that magnetic force deterioration of the permanent magnet located in the rotor inside the motor has been detected. The cause of this malfunction may be one of the following: Area Main Malfunction Description Step Inverter low-voltage
© 2016-2026 Copyright www.lexunx.com
